THRUSH AIRCRAFT, INC – MODEL S2R-R1340
The mixture control requires
a control rod movement of
approximately 1-5/16 inches.
The control lever has a 75 to
80 degree radial travel.
E. Install access panels.
CLEANING FUEL STRAINER
The carburetor fuel strainer should be
removed
and
cleaned
STARTER
A 28-volt dc, direct cranking electric
starter is mounted on the upper rear
4-12
AIRCRAFT MAINTENANCE MANUAL
at
periodic
Figure 4-4: Carburetor and Air Induction
intervals.
To remove strainer, proceed
as follows:
A. Cut safety wire and remove strainer
from carburetor.
B. Wash strainer in approved solvent.
Clean
strainer
foreign material.
C. Reinstall strainer, tighten and safety
wire.
section of the engine (see Figure 4-1).
When the starter is energized through
the starter relay, the starter jaw is
mechanically engaged with the engine
chamber
of
any
Effective: 01/01/2008