Victoria Arduino theresia User Manual page 66

9. CLEANING AND
MAINTENANCE
9.1 SWITCHING
MACHINE
To switch the machine off, press the main
switch and set the machine to the "O"
position.
9.2 CLEANING THE OUTSIDE
OF THE MACHINE
The machine must be set to "O" power
(switch off and disconnector open) be-
fore any cleaning operations.
WARNING
Do not use solvents, chlorine-based
products or abrasives.
WARNING
It is not possible to clean the machine us-
ing water jets or immersing it in water.
Cleaning the work area: remove the
worktop grid, lifting it up from the front
and sliding it out. Remove the water col-
lection dish underneath and clean with
hot water and cleansers.
Cleaning the bottom: To clean all the
chromium-plated areas, use a soft, damp
cloth.
66
9.3 CLEANING THE STAINLESS
The stainless steel coffee holder is situ-
ated underneath the dispensing unit.
OFF THE
To clean proceed as follows:
9.4
The machine is pre-set for cleaning the
delivery unit with a specific washing
powder.
The machine will initiate washing cycle
which consists in the circulation of hot
water followed by regular breaks.
We recommend carrying out a washing
cycle at least once a day with special
cleansers.
Once the filter-holder has been removed,
repeat delivery operations a few times to
eliminate any cleanser residues.
To carry out the washing procedure,
01. Substitute the filter with the delivery
02. Fill it with two spoonfuls of special
03. Press the Hot water
STEEL COFFEE-HOLDERS
NOTE
Turn the screw placed in the centre of
the coffee-holder.
Slide the coffee-holder out and check
that its holes are not obstructed.
If obstructed, clean as described
(Paragraph "CLEANING FILTERS AND
FILTER-HOLDERS").
It is recommended to clean the
coffee-holder once a week.
CLEANING THE UNIT WITH
THE AID OF THE BLIND FILTER
RISK OF INTOXICATION
proceed as follows:
unit blind filter.
cleanser powder and insert it into the
unit filter-holder.
keys at the same time, and then press
ENTER to restart the cleaning.
EN
and Steam