Canon MX882 Service Manual page 64

<#1 BIT SWITCH>
1. In the #1 BIT SWITCH menu, the following screen is displayed:
PTT PRAMETER
#1 BIT SWITCH
SW#01 00000000
2. Each time the up or down cursor button (or the OK button) is pressed, the SW# changes from 01 to 20.
Be cautious not to select the SW numbers which are not used in servicing.
The SW numbers used in servicing: SW# 01, 02, 03, 04, 05, 06, 07, 10, 11, 13
The SW numbers not used in servicing (as of December 2007): SW# 08, 09, 12, 14 to 20
3. Each SW# has 8-bit information. Using the left or right cursor buttons, move the cursor to the bit to be
changed, and enter the setting value (1 or 0).
Bit7 -> 00000000 <- Bit0
4. Press the OK button to finalize the setting value. For the definition and description of each bit of each SW#,
refer to the " G3 Facsimile Service Data Service Handbook."
English: QY8-13BC-010
Japanese: QY8-12B6-020
5. Press the Stop button to save the setting value.
6. Press the ON button.
<#2 NUMERIC PARAM.>
1. In the #2 NUMERIC PARAM. menu, the following screen is displayed:
PTT PRAMETER
#2 NUMERIC
PARAM
01: 00000
2. Each time the up or down cursor button (or the OK button) is pressed, the SW# changes from 01 to 60.
Be cautious not to select the SW numbers which are not used in servicing.
The SW numbers used in servicing: SW# 01, 02, 04 to 09, 16 to 24, 26, 27, 30, 31, 41, 42
The SW numbers not used in servicing (as of December 2007): SW# 03, 10 to 15, 25, 28, 29, 32 to 40, 43 to
60
3. Enter a desired setting value, using the right or left cursor button or numeric buttons.
(Specifiable values vary depending on the item.)
4. Press the OK button to finalize the selected setting value. For the definition and description of each bit of the
SW#, refer to the " G3 Facsimile Service Data Service Handbook."
English: QY8-13BC-010
Japanese: QY8-12B6-020
5. Press the Stop button to save the setting value.
6. Press the ON button.
60 / 76