Canon MX882 Service Manual page 10

Ink tank not [1660] U043 The following ink
installed.
Print head not [1401] U051 Print head is not
installed, or not
properly
installed.
Faulty print
head ID.
Print head [1403]
temperature
sensor error.
Faulty [1405]
EEPROM data
of the print
head.
Multiple ink [1487] U071 More than one ink
tanks of the
same color
installed.
Ink tank in a [1680] U072 Some ink tanks are
wrong position.
Warning: The [1700]
ink absorber
becomes almost
full.
The connected [2001]
digital camera
or digital video
camera does not
tank cannot be
recognized.
(Applicable ink tank
icon)
installed. Install the
print head.
U052 The type of print head
is incorrect. Install the
correct print head.
tank of the following
color is installed.
not installed in place.
--- The ink absorber is
almost full. Press
[OK] to continue
printing. Contact the
service center.
--- Incompatible device
detected. Remove the
device.
run out during printing.
Install the applicable ink
tank(s) properly, and
confirm that the LED's of
all the ink tanks light red.
Install the print head
properly.
If the error is not cleared,
confirm that the print head
contact pins of the carriage
are not bent.
Re-set the print head. If the
error is not cleared, the
print head may be
defective. Replace the print
head. If the error is not
cleared, confirm that the
print head contact pins of
the carriage are not bent.
Replace the wrong ink tank
(s) with the correct one(s).
Install the ink tank(s) in
the correct position.
Replace the ink absorber,
and reset its counter. [See
3-3, Adjustment and
Settings in Service
Pressing the OK button
will exit the error, and
enable printing without
replacing the ink absorber.
However, when the ink
absorber becomes full, no
further printing can be
performed unless the
applicable ink absorber is
replaced.
Remove the cable between
the camera and the
machine.
5 / 76
- Ink tank
- Carriage unit
- Print head
- Carriage unit
- Print head
- Carriage unit
- Ink tank
- Ink tank
- Absorber kit
Mode.]