Lennox 11U61 Setup And Installation Manual page 21

tests equipment
setup
current test: Blower
Check Blower Operation
Heating Rate
Blower CFM Demand
Blower Off Delay
Blower On Delay
Indoor Blower RPM
Indoor Blower Power
Flame Current
Flame Sense
Outdoor Temperature
9:39 am Aug 15, 2012
Figure 17. Typical Tests Results Screens
tests equipment
setup
The Testing Process is finished
press 'tests' button to run more tests
press 'EXIT' button to start normal operation
9:39 am Aug 15, 2012
Figure 18. Testing Finished Screen
alerts diagnostics
%
1400CFM
Off
Off
0
0.0000%
0.000mA
No Flame
63ºF
cancel next
diagnostics
alerts
cancel next
21
Touch confirm to continue system configuration; the
screen will change to the system discovery screen. At
this point, the program goes through the same set up as
the initial set up process which begins on page 3.
NOTE - "Compatible device found" screen (shown
below) appears only when a device has been removed
and replaced with a compatible device.
Missing
Device Equipment Type No.
Model No. (control model no.)
Serial No. (control serial no.)
Settings were not copied
®
iComfort Equipment Interface Module
®
The iComfort Equipment Interface Module (EIM) can
be configured in the following set ups:
Thermostat, Equipment Interface Module with a
(conventional) indoor and outdoor units.
1. Wiring—See Communicating
Optional Accessories Wiring diagrams.
4-conductor thermostat wire from the iComfort
D
®
Wi‐Fi Flex thermostat to the equipment
interface module (R, i+, i-, C)
Up to 8-conductor thermostat wire from the
D
conventional furnace and outdoor unit terminal
strips to the equipment interface module (R, C,
O, Y1, Y2, G, W1, W2 and W3).
Wiring as required for accessories
D
2. DO NOT cut any option link on furnace control.
7-Day Programmable iComfort Wi‐Fi
Found Compatible
Device Equipment Type No.
Model No. (control model no.)
Serial No. (control serial no.)
System
®
Flex Thermostat
and