Lennox 11U61 Setup And Installation Manual page 18

Basic Dew Point Control adjustment mode will change
the humidification setpoint based on the outdoor
temperature and a user-defined dew point adjustment
setting.
Precision Dew Point Control adjustment mode will
operate when these conditions are met:
• humidification mode has been enabled, and
• the unit is in HEAT mode, and
• humidification demand exists (24V present at H).
HUMIDIFICATION SETTINGS — FEATURE
SCREEN
SYSTEM SETTINGS
humidification
settings
%
40
humidifier
is ON
set to
ALL CHANGES MADE ON
THIS SCREEN ARE IN­
STANTLY SAVED.
Wi-Fi
9:39 am Aug 15, 2012
Figure 14. Humidification Controls
1. From the Main Screen, touch the right arrow icon
to go the the Features screen.
2. From the Features screen, select system settings.
507428-01
dehumidification
settings
OFF
de-
%
humidifier
50
MEDIUM
MEDIUM
set to
HIGH
current indoor humidity is 50%
3. Touch the button of the humidification settings you
want to adjust; if it says humidifier OFF, one touch
will display a selection for ON.
4. When you touch the set-to button, the arrows
appear, allowing you to change to the desired
humidity percentage setting.
DEHUMIDIFICATION SETTINGS — SYSTEM
DEVICES SCREEN
Pre-adjustment REQUIREMENTS
• First the device has been installed
• Second,
Non-communicating equipment?", touch next.
• Third, in the "Adjust a setting..." screen, configure
the device as follows:
1. In the "system devices" list, use the arrows to
highlight System. Touch edit.
humidifier
2. Use arrows to highlight Min Dehumidification
display
is ON
Setpoint; touch edit. Note the current value (e.g.
45).
3. Use arrows to make changes; touch (After saving,
check that the current value now shows the new
selection).
?
4. Touch the back button to return to "Adjust a
setting..." screen.
DEHUMIDIFICATION SETTINGS — FEATURE
SCREEN
1. From the Main Screen, touch the right arrow icon
to go the the Features screen.
18
from the "Add or Remove