Installing The Processor Option - HP Synergy 480 Gen9 User Manual

4. Remove the access panel.
5. Remove the DIMM baffle.
6. Install the DIMM.
2
7. Install all DIMM baffles.
8. Install the access panelInstall the access panel.
9. Install the compute module.
10. Power up the compute module.
To configure the memory mode, use UEFI System Utilities.

Installing the processor option

WARNING:
To reduce the risk of personal injury from hot surfaces, allow the drives and the internal system
components to cool before touching them.
CAUTION:
To prevent possible compute module malfunction and damage to the equipment, multiprocessor
configurations must contain processors with the same part number.
CAUTION:
The heatsink thermal interface media is not reusable and must be replaced if the heatsink is removed
from the processor after it has been installed.
CAUTION:
To prevent possible compute module overheating, always populate processor socket 2 with a processor
and a heatsink or a processor socket cover and a heatsink blank.
CAUTION:
To prevent damage to electrical components, properly ground the compute module before beginning
any installation procedure. Improper grounding can cause ESD.
IMPORTANT:
Processor socket 1 must be populated at all times or the compute module does not function.
To install the processor:
38 Installing the processor option
1
2