Installing The Trusted Platform Module Board - HP Synergy 480 Gen9 User Manual

CAUTION:
Always observe the guidelines in this document. Failure to follow these guidelines can cause hardware
damage or halt data access.

Installing the Trusted Platform Module board

WARNING:
To reduce the risk of personal injury from hot surfaces, allow the drives and the internal system
components to cool before touching them.
To install the component:
Procedure
1. Power down the compute module.
2. Remove the compute module.
3. Place the compute module on a flat, level work surface.
4. Remove the access panel.
5. Remove all drives.
6. Remove all drive blanks.
7. Remove all DIMM baffles.
8. Remove the front panel/drive cage assembly.
9. Locate the TPM connector.
CAUTION:
Any attempt to remove an installed TPM from the system board breaks or disfigures the TPM
security rivet. Upon locating a broken or disfigured rivet on an installed TPM, administrators should
consider the system compromised and take appropriate measures to ensure the integrity of the
system data.
10. Install the TPM board. Press down on the connector to seat the board (System board components).
11. Install the TPM security rivet by pressing the rivet firmly into the system board.
Installing the Trusted Platform Module board 43