Settings For The Wireless Lan; Instructions For Lanconfig - Lancom L-310agn Wireless Manual

In the managed mode the LANCOM Wireless Routers and LANCOM

Access Points automatically receive the same root password as the
WLAN-Controller, assuming that no root password has been set in the
device itself.
3.1.3

Settings for the wireless LAN

There is a handy installation wizard to help you with the LANCOM Access
Point's wireless LAN configuration. After performing the basic configuration
please execute the wizard to configure the wireless LAN interface
configuration with the wizards in LANconfig').
3.2

Instructions for LANconfig

Start LANconfig with Start
LANconfig automatically detects new LANCOM devices in the TCP/IP net-
work.
If the search detects an unconfigured device, the Setup Wizard launches
to help you with its basic settings, or indeed to handle the entire process
on your behalf (assuming that the appropriate networking environment
exists).
If the Setup Wizard does not start automatically, you can manually

search for new devices at all interfaces (if the L-300 Access Point is
connected via the serial configuration interface) or in the network
(File
If you cannot access an unconfigured L-300 Access Point, the problem

may be the LAN netmask: In case there are less than 254 potential
hosts available (netmask >'255.255.255.0'), you must ensure that the
IP address 'x.x.x.254' is available in your subnet.
Programs
Find devices).
LANCOM L-300 Access Point series
Chapter 3: Basic configuration
LANCOM LANconfig.
(→ 'WLAN
37