Setting Up Hyperterminal - Laversab 6300 User Manual

where the Static port is put into Leak mode at 18,000 feet.
9. Caution: If you are using Mach on the Pitot side, make sure that while the Static side
is moving from a low altitude to a higher altitude, the target Mach number must be
kept low (about 0.200). After the higher altitude is achieved, the Mach number can
be increased to the desired value. This must be done to prevent a high Mach number
at a low altitude causing an excessive airspeed (knots) to be generated. For example,
if you want to achieve 0.800 Mach at 30,000 feet, 35,000 feet and 40,000 feet then your
profile points must be set up as follows:
Mach Control
Mach Control
Mach Control
Mach Control
Notice how the Mach is kept low until 30,000 feet is achieved. Then it is ramped to
0.800 which would be an acceptable airspeed. Once this first point is achieved you
do not have to lower Mach again because for altitudes of 35,000 and 40,000 feet, the
same Mach number would actually result in a lower airspeed and the unit will
automatically control this without any damage to the aircraft instruments.
10. Now that the profile is complete, save the profile as an Excel file ( .xls file) using the
name of the profile as the filename. Then save it again using the "Save As"
command but this time change the file type (using the "Save as type:" drop-down
selection ) to "Text - Tab delimited". Use the profile name as the filename again.
You will get many warnings from Excel about the incompatibility of this text file, but
simply say "Yes" to all the warnings. Once you have saved the file as a text file, you
will need to close the file. When you do this, many more warnings will pop up.
Please say "yes" to all these too.
11. At the end, you should have two files for your new profile. One .xls file and one .txt
file, both with the same filename. Your profile has been created.

4.3 SETTING UP HYPERTERMINAL

You download a profile into the 6300 using the Hyperterminal program. At first you need
to setup Hyperterminal. You only need to do this once.
1. Hyperterminal comes loaded in your PC as part of the accessories. Go into "All
Programs", then select "Accessories", then select "Communication", then select
Hyperterminal. It will ask you to setup a new connection. Create a new connection
with the name "6300". A dialog box named "Connect To" will appear. The bottom
selection in this box is "Connect using". From the drop down menu in "Connect
using", select "COM1". Select "OK". A new dialog box will open named "Com1
0.200 Feet Control
0.800 Feet Control
0.800 Feet Control
0.800 Feet Control
44
30000 6000
30000 6000
35000 6000
40000 6000