Laversab 6300 User Manual page 32

Units:
Actual:
Target:
Pt mode :
Move the cursor to the desired mode and then press ENTER. The selected mode is displayed
on the screen and blinks until the GO key is pressed. The new mode will not become effective
until the GO key is pressed. The sample screen below shows the selected Pitot mode as
"LEAK". Notice that the "L" on the left in line 2 is blinking.
Units:
Actual:
Target:
Important note:
Pitot and Static outputs are automatically changed to Control. During normal operation
you want both Static and Pitot outputs connected to the aircraft and both of them achieving
a specific target value. Leaving one output in Measure or Leak and the other output in
Control should be done only during a Leak check.
Static Mode:
Measure (M), Leak (L) and Control (C). The power-up mode defaults to Measure (M). To
change the mode press the Ps Mode key. The three modes will be displayed on line 4 of the
display, with the cursor under the Measure mode. The UP ARROW key can be used for
moving the cursor left and the DOWN ARROW key can be used to move the cursor right.
The cursor wraps around the selections, that is, moving the cursor left past "MEAS" wraps it
around to "CTRL". The sample screen below shows the three mode choices displayed on line
4 of the display, with the cursor under "MEAS".
Units:
Actual:
Target:
Ps mode :
Move the cursor to the desired mode and then press ENTER. The selected mode is displayed
on the screen and blinks until the GO key is pressed. The new mode will not become effective
until the GO key is pressed. The sample screen below shows the selected Static mode as
knots
M 101.2
20.0
MEAS, LEAK, CTRL
knots
L 101.2
20.0
When either the Pitot or Static Mode is changed to Control (C), BOTH
The Static output has three modes of operation. The three mode are
knots
M 101.2
20.0
MEAS, LEAK, CTRL
Feet/min
3500
3000
Feet/min
3500
3000
Feet/min
3500
3000
25
Feet
1005 M
0
Feet
1005 M
0
Feet
1005 M
0