Laversab 6300 User Manual page 40

After the pump section test has passed successfully, the screen is cleared and the status of the
remaining tests is displayed as shown below.
Pump section OK
Ps control system OK
Pt control system OK. Tests successful.
After the tests have been completed successfully, press the CANCEL key to return to the Main
Operating Screen.
If any of the tests fail, then note the failure, turn OFF the unit and contact the factory.
3.5 FUNCTION SELECT SCREEN
There are 10 different functions that can be performed. These are:
0. Set IEEE address
1. View Limits
2. Set or Change Limits
3. Set or Change the knots rate
4. View or Execute profiles
5. Setup profiles
6. Height Correction
7. Set Ground
8. Go To Ground
9. Encoder
Pressing the "Function Select" key on the keypad allows you to go into the function select
screen which is shown below.
Select function
0. IEEE address = 5
1. View limits
3. Set knots rate ... now at 500.0 kts/min
If you want to select functions 4 through 9, press the Down Arrow key on the keypad to move
to the screen shown below.
( DN ARROW for functions 4 to 9 )
2. Set limits
33