Okofen PE 08 Operating Manual page 166

166
Display:
Description:
Cause and Remedy:
13.15 Flame return gate BSK (5038, 5039, 5040)
Display:
Description:
Cause and Remedy:
Display:
Description:
Cause and Remedy:
Display:
Description:
Cause and Remedy:
13.16 Suction system (Fault 5043)
Display:
Description:
Cause and Remedy:
PE 567 EN 1.1
Not enough draught
Flue gas sensor or flamm-
roomtemperature-sensor
soiled
[5036] PE Flame supervision fault
Flame supervision fault, minimum flue gas temperature not reached during
heating up at full power – Input FRT
No pellets available
[5038] PE Flame return gate open
Flame return gate open fault (BSK - 1 2)
Flame return gate
unplugged
Flame return gate does
not reach OPEN limit
switch
No signal although open
[5039] PE Flame return gate closed
Flame return gate open fault
Flame return gate
unplugged
Flame return gate does
not reach CLOSE limit
switch
No signal although closed
[5040] PE Flame return gate limit switch
Both flame return gate limit switches (BSK 1-2 and BSK 3-4) are closed at the
same time
Both limit switches
activated
Suction system
Hopper cannot be filled up even after 3 suction cycles
Storage room empty
Extraction system is
blocked
Extraction system not con-
veying pellets
Check ventilation flap, funktion radial fan,
draught free
Check Flue gas sensor or flammroom-tem-
perature-sensor
Fill up with pellets
Connect up flame return gate and check
cable connections
Check ball valve to see if it is jammed
Check cables and flame return gate
Connect up flame return gate and check
cable connections
Check whether ball valve is jammed, check
ball valve throughway to see if foreign ob-
jects are preventing it from closing
Check cables and flame return gate
Check flame return gate, check cables,
check connectors
Fill up with pellets
Clear extraction system
Pellet bridge - destroy bridge and make sure
material flows properly
Malfunction report