Okofen PE 08 Operating Manual page 149

IP Config
Remote maintenance access
The settings are set as follows:
• DHCP Off
• Ping On
• Port 8080
• Remote maintenance: Automatic
The port of the touch panel must correspond to the external shared
port.
The touch then registers with the external IP address and port on Ök-
oFEN remote maintenance server.
In case of change of address by the external provider, this is detected
and sent to the ÖkoFEN server.
Static:
In this mode, no connection data is transferred to the ÖkoFEN server
and the online service of ÖkoFEN can not be used.
But the remote controll of the Touch operating device remains active
and can be uses as before via port forwarding, DynDns, fixed external
IP, LAN and so on.
All functions for the network/internet can be disabled here.
Back to the menu General.
This function determines the network settings
automatically.
For this the DHCP mode is activated and the re-
quired settings are set automatically.
Afterwards DHCP is deactivated.
Because of this, the IP address of the contol unit
can change.
Operating Manual PELLEMATIC® PE(S)(K)(B) 10 — 56
149