Indicators On Lcd - Mandik KFR-09GW/BP User Manual

24

Indicators on LCD

EN
Information are displayed when the remote control-
ler is powered up
Mode display
Displayed when data transmitted
Displayed when remote controller is ON
Battery display (low battery detection)
Displayed in ECO operation
Displayed when TIMER ON time is set
Displayed when TIMER OFF time is set
Show set temperature or room tempera-
ture, or time under TIMER setting
Not available for this unit
Not available for this unit
Not available for this unit
Displayed when Silence function is
activated
Fan speed indication
NOTE:
All indicators shown in the figure are for the purpose of
clear presentation. But during the actual operation only
the relative functional signs are shown on the display
window.
Low speed
Mediumspeed
High speed
Auto fan speed
How to use the buttons
Auto operation
Ensure the unit is plugged in and
power is available The OPERATION
indicator on the display panel of
the indoor unit starts flashing
1 Press the MODE button to se-
lect Auto
2 Press the Up/DOWN button to
set the desired temperature
The temperature can be set
within a range of 62 o F~ 86 o F in
1 o F increments
3 Press the ON/OFF button to
start the air conditioner
NOTE:
1. In the Auto mode, the air con-
ditioner can logically choose
the mode of Cooling, Fan, and
Heating by sensing the difference
between the actual ambient
roomtemperature and the set-
ting temperature on the remote
controller.
2. In the Auto mode, you can not
switch the fan speed. It has al-
ready been automatically con-
trolled.
3. If the Auto mode is not comforta-
ble for you , the desired mode can
be selected manually.
Cooling /Heating/Fan
operation
Ensure the unit is plugged in and
power is available
1 Press the MODE button to
select COOL, HEAT(cooling &
heating models only) or FAN
mode
2 Press the Up/DOWN buttons to
set the desired temperature
3 Press the FAN button to select
the fan speed in four steps-
Auto, Low, Med, or High
4 Press the ON/OFF button to
start the air conditioner
NOTE:
In the FAN mode, the setting temper-
ature is not displayed in the remote
controller and you are not able to
control the roomtemperature either.
In this case, only step 1, 3 and 4 may
be performed.