Operation Of Buttons - Mandik KFR-09GW/BP User Manual

Operation of buttons

1 ON/OFF Button
This button turns the air conditioner ON and OFF
2 MODE Button
Press this button to modify the air conditioner mode in
a sequence of following:
AUTO COOL
NOTE: Please do not select HEAT mode if the machine you
purchased is cooling only type. Heat mode is not supported
by the cooling only appliance.
3 FAN Button
Used to select the fan speed in four steps:
AUTO LOW
NOTE: You can not switch the fan speed in AUTO or DRY
mode.
4
ECO Button
Used to enter the energy efficient mode Under cooling
mode, press this button, the remote controller will adjust
the temperature automatically to 75 o F, fan speed of Auto
to save energy(but only if the set temperature is less than
75 o F) If the set temperature is between 75 o F and 86 o F,
press the ECO button, the fan speed will change to Auto,
the set temperature will remain unchanged
NOTE:
Pressing the TURBO and MODE button, modifying the
„ „
mode or adjusting the set temperature to less than 75 o F
will stop ECO operation.
Under ECO operation, the set temperature should be 75 o F
„ „
or more. it may result in insufficient cooling. If you feel
uncomfortable, just press the ECO button again to stop it.
5
TURBO Buttonn
Active/Disable Turbo function Turbo function enables the
unit to reach the preset temperature at cooling or heating
operation in the shortest time(if the indoor unit does not
support this function, there is no corresponding operation
happened when pressing this button )
6 Up Button ()
Push this button to increase the indoor temperature set-
ting in 1 o F increments to 86 o F
DOWN Button ()
Push this button to decrease the indoor temperature set-
ting in 1 o F increments to 62 o F
NOTE: Temperature contol is not available in Fan mode.
NOTE: Press and hold Up and DOWN buttons together for
3 seconds will alternate the temperature display between the
o C & o F scale.
7 SILENCE Button
Active/Disable Silence function When the Silence function
is activated, the compressor will operate at low frequency
and the indoor unit will bring faint breeze, which will re-
duce the noise to the lowest level and create a quiet and
comfortable roomfor you Due to low frequency operation
of compressor, it may result in insufficient cooling and
heating capacity
DRy HEAT FAN
MED HIGH
8
TIMER ON Button
Press this button to initiate the auto-on time sequence
Each press will increase the auto-timed setting in 30 min-
utes increments When the setting time displays 10 0, each
press will increase the autotimed setting 60 minutes incre-
ments To cancel the auto-timed program, simply adjust
the auto-on time to 0 0
9 TIMER OFF Button
Press this button to initiate the auto-off time sequence
Each press will increase the auto-timed setting in 30 min-
utes increments When the setting time displays 10 0, each
press will increase the auto-timed setting 60 minutes incre-
ments To cancel the autotimed program, simply adjust the
auto-off time to 0 0
10 SWINGButton
Used to stop or start horizontal louver auto swing feature
11
DIRECT Button
Used to change the louver movement and set the desired
up/down air flow direction
The louver changes 6 o in angle for each press
12
LED Button
Disable/Active indoor screen Display When pushing the
button, the indoor screen display is cleared, press it again
to light the display
23
EN