How The Air Conditioner Works - Mandik KFR-09GW/BP User Manual

18

How the air conditioner works

EN
Set
Temperature
1 o C / 2 o F
1 hour
Set
Temperature
1 hour
Care and Maintenance
Filter Handle
SLEEP operation
7 hours timer off
1 o C / 2 o F
1 hour
Cooling
SLEEP operation
7 hours timer off
1 o C / 2 o F
1 o C / 2 o F
1 hour
Heating
AUTO operation
When you set the air conditioner in AUTO mode, it will automatically select
„ „
cooling, heating(cooling/heating models only), or fan only operation de-
pending on set temperature and the room temperature
The air conditioner will control room temperature automatically to the tem-
„ „
perature point you set
If you feel uncomfortable in the AUTO mode, you can set your desired tem-
„ „
perature
SLEEp operation
When you push SLEEP button on remote controller during cooling, heat-
ing(cooling & heating models only), or AUTO operation, the air conditioner will
automatically increase (cooling) or decrease (heating) 1 o C / 2 o F per hour for
the first 2 hours, then hold steadily for the next 5 hours, after that it will switch
off This mode saves you energy and brings you comfort at night
DRYING operation
The fan speed will be automatically controlled under dry operation
„ „
During the dry operation, if the room temperature is lower than 10 o C
„ „
(50 o F), the compressor stops operation and restarts until the room temper-
ature is above 12 o C / 54 o F
Optimal operation
„ „ To achieve optimal performance, please note the following:
Adjust the air flow direction correctly so that it is not forwards people
„ „
Adjust the temperature to achieve the highest comfort level Do not adjust
„ „
the unit to excessive temperature levels
Close doors and windows on COOL or HEAT modes, or performance may
„ „
be reduced
Use TIMER ON button on the remote controller to select a time you want to
„ „
start your air conditioner
Do not put any object near air inlet or air outlet, as the efficiency of the
„ „
air conditioner may be reduced and the air conditioner may stop running
Clean the air filter periodically, otherwise cooling or heating performance
„ „
may be reduced
Do not operate unit with horizontal louvre in closed position
„ „
Before mainatenance
Turn the system off before cleaning To clean, wipe with a soft, dry cloth Do
„ „
not use bleach or abrasives
NOTE: Power supply must be disconnectd before cleaning the indoor unit.
„ „ A cloth dampened with cold water may be used on the indoor unit if it is
very dirty Then wipe it with a dry cloth
„ „ Do not use a chemically treated cloth or duster to clean the unit
Do not use benzine, thinner, polishing powder, or similar solvents for clean-
„ „
ing These may cause the plastic surface to crack or deform
Never use water hotter than 40 o C/104 o F to clean the front panel
„ „
CAUTION