How To Use The Buttons - Mandik KFR-09GW/BP User Manual

How to use the buttons

Dehumidifying operation
Ensure the unit is plugged in and
power is available The OPERATION
indicator on the display panel of
the indoor unit starts flashing
1 Press the MODE button to se-
lect DRy mode
2 Press the Up/DOWN buttons
to set the desired temperature
The temperature can be set
within a range of 62 o F ~ 86 o F in
1 o F increments
3 Press the ON/OFF button to
start the air conditioner
NOTE:
In the Dehumidifying mode, you can
not switch the fan speed. It has al-
ready been automatically controlled.
Timer operation
Press the TIMER ON button can set the auto-on time of the unit Press the
TIMER OFF button can set the auto-off time of the unit
To set the Auto-on time.
1 Press the TIMER ON button
The remote controller shows
TIMER ON, the last Auto-on
setting time and the signal
"H" will be shown on the LCD
display area Now it is ready
to reset the Auto-on time to
START the operation
2 Push the TIMER ON button
again to set desired Auto-on
time Each time you press the
button, the time increases by
half an hour between 0 and
10 hours and by one hour be-
tween 10 and 24 hours
3 After setting the TIMER ON,
there will be a one second
delay before the remote con-
troller transmits the signal
to the air conditioner Then,
after approximately another
2 seconds, the signal "h" will
disappear and the set tem-
perature will re-appear on
the LCD display window
„ „ When you select the timer operation, the remote controller automat-
ically transmits the timer signal to the indoor unit for the specified
time Therefore, keep the remote controller in a location where it can
transmit the signal to the indoor unit properly
„ „ The effective operation time set by the remote controller for the tim-
er function is limited to the following settings: 0 5, 1 0, 1 5, 2 0, 2 5,
3 0, 3 5, 4 0, 4 5, 5 0, 5 5, 6 0, 6 5, 7 0, 7 5, 8 0, 8 5, 9 0, 9 5, 10, 11, 12, 13,
14, 15,16,17, 18, 19, 20, 21, 22, 23 and 24
To set the Auto-off time.
1 Press the TIMER OFF button
The remote controller shows
TIMER OFF, the last Auto-off
setting time and the signal
"H" will be shown on the LCD
display area Now it is ready
to reset the Auto-off time to
stop the operation
2 Push the TIMER OFF button
again to set desired Auto-off
time Each time you press the
button, the time increases by
half an hour between 0 and
10 hours and by one hour be-
tween 10 and 24 hours
3 After setting the TIMER OFF,
there will be a one second
delay before the remote con-
troller transmits the signal
to the air conditioner Then,
after approximately another
2 seconds, the signal "H" will
disappear and the set tem-
perature will re-appear on
the LCD display window
CAUTION
25
EN