Removing And Replacing A 3.5-Inch Hard Drive - HP ProDesk 600 G3 Maintenance And Service Manual

6. Connect the power cable (1) and data cable (2) to the rear of the drive.
7. Connect the opposite end of the data cable to the light blue SATA connector on the system board labeled
SATA1.
NOTE:
connectors.

Removing and replacing a 3.5-inch hard drive

CAUTION:
1. Prepare the computer for disassembly
2. Disconnect the data cable (1) and power cable (2) from the rear of the hard drive.
IMPORTANT:
damaging the cable.
38 Chapter 4 Removal and replacement procedures: Small Form Factor
Refer to System board connections on page 33
All removable media should be taken out of a drive before removing the drive from the computer.
When removing the cables, pull the tab or connector instead of the cable itself to avoid
for an illustration of the system board drive
(Preparation for disassembly on page 20).