Drive Cage - HP ProDesk 600 G3 Maintenance And Service Manual

Drive cage

You must remove the drive cage to access most computer components.
1. Prepare the computer for disassembly
2. Remove the access panel
3. Disconnect the power and data cables from the rear of all drives in the drive cage.
4. To remove the drive cage, push the release lever on the left side of the cage inward (1), lift the left side
of the cage up (2), and then slide the right side of the cage out of the chassis (3).
5. To replace the drive cage, slide the tabs on the left side of the drive cage into the slots on the chassis (1),
and then press the right side of the drive cage down onto the chassis (2).
(Preparation for disassembly on page
(Access panel on page 21).
20).
Drive cage 25