Expansion Card - HP ProDesk 600 G3 Maintenance And Service Manual

Expansion card

Description
NVIDIA GT730 2 GB DDR3 PCIex8 graphics card
NVIDIA GT730 1 GB DDR3 PCIex8 graphics card
Intel PRO/1000 NIC
Parallel (printer) port
USB 3.1 Type Cx1 PCIe x1 card
The computer has one PCI Express x4 expansion socket and one PCI Express x16 expansion socket.
NOTE: The PCI Express sockets support only low profile cards.
You can install a PCI Express x1, x4, x8, or x16 expansion card in the PCI Express x16 socket.
For dual graphics card configurations, the first (primary) card must be installed in the PCI Express x16 socket.
To remove, replace, or add an expansion card:
1. Prepare the computer for disassembly
2. Remove the access panel
3. Locate the correct vacant expansion socket on the system board and the corresponding expansion slot
on the back of the computer chassis.
4. Rotate the slot cover release latch to the open position.
5. Before installing an expansion card, remove the expansion slot cover or the existing expansion card.
NOTE:
the expansion card.
(Access panel on page
Before removing an installed expansion card, disconnect any cables that may be attached to
(Preparation for disassembly on page
21).
20).
Expansion card 29