Pro-Form 490 CX User Manual page 6

ASSEMBLY
Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is
coated with high-performance lubricant. During shipping, lubricant may be transferred to the top of the walking
belt or the shipping carton. This is a normal condition and does not affect treadmill performance. If there is lubri-
cant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.
Assembly requires the included hex keys and your own phillips screwdriver
ters , and adjustable spanner
For help identifying assembly hardware, see the drawings below. Note: If a part is not found in the part bags,
check to see if the part has been preattached.
1/4" x 1" Bolt
5/16" x 1" Bolt
3/4" Screw (33)–5
(88)–8
(113)–4
5/16" x 3 1/2" Bolt (121)–2
1. With the help of a second person, carefully raise the
Uprights (96) to the position as shown.
Insert one of the Extension Legs (86) into the treadmill as
shown. Make sure that the Extension Leg is turned so
the Base Pad (125) is underneath it. If necessary, tip the
Uprights (96) forward as you insert the Extension Leg.
Insert the other Extension Leg (not shown) in the same
way.
,wire cut-
.
1" Tek Screw 1/2" Screw (52)–1
(123)–4
1/4" Star Washer
(87)–8 5/16" Washer (130)–2
1
96
86
125
6
b. If the walking belt slips when walked on, first remove the
key and UNPLUG THE POWER CORD. Using the hex
key, turn both rear roller bolts clockwise 1/4 of a turn.
When the walking belt is correctly tightened, you should
be able to lift each edge of the walking belt 7 to 10 cm (3
to 4 in.) off the walking platform. Be careful to keep the
walking belt centred. Then, plug in the power cord, insert
the key, and walk on the treadmill for a few minutes.
Repeat until the walking belt is properly tightened.
PROBLEM: The incline of the treadmill does not change correctly
SOLUTION: a. With the key in the console, press one of the Incline buttons. Whilst the incline is changing, re-
move the key. After a few seconds, reinsert the key. The treadmill will automatically rise to the
maximum incline level and then return to the minimum level. This will recalibrate the incline system.
b
27