Program Without Using Utility Package - Mitsubishi QJ71MT91 User Manual

9 PROGRAMMING

9.3.3 Program without using utility package

Parameter
Basic parameters
Automatic communication
parameters
MODBUS device assignment
R
parameters
1: To utilize the basic parameters with the initial values (refer to Section 7.2.1), it is recommended to use the default
parameters.
2: When the device assignment of the CPU is not changed, it is recommended to use the default parameters.
9 - 39
(1) Intelligent function module switch setting
Set the intelligent function module switches by clicking Switch setting on <<I/O
assignment>> of GX Developer.
Refer to Section 9.2.3 (1) for the intelligent function module switches.
(2) Parameter setting
Set the parameters using a sequence program.
Parameter setting can be omitted under the following conditions.
Condition
Use the default parameters. ( 1)
Do not use the automatic
communication function (master
function).
Use the default parameters. ( 2)
Do not use the MODBUS
assignment function (slave function).
(a) Basic parameters
Execute Basic parameter setting request (Y1001) after writing the basic
parameters to the buffer memory by the REMOTO instruction.
For a program example for basic parameter setting, refer to <<Basic
parameter setting>> in (6) (b) in this section.
(b) Automatic communication parameters
Execute Automatic communication parameter setting request (Y1004) after
writing the automatic communication parameters to the buffer memory by
the REMOTO instruction.
For a program example for automatic communication parameter setting,
refer to <<Automatic communication parameter setting>> in (6) (b) in this
section.
(c) MODBUS
Execute MODBUS
after writing the MODBUS
memory by the REMOTO instruction.
For a program example for MODBUS
setting, refer to <<MODBUS device assignment parameter setting>> in (6)
(b) in this section.
Parameter Setting Omitting Condition
With the intelligent function module switch 2, set
the basic parameter starting method (bit 0) to "0:
Start with the default parameters". (Refer to
Section 9.2.3 (1).)
No need to set.
With the intelligent function module switch 2, set
the MODBUS
starting method (bit 1) to "0: Start with the default
parameters". (Refer to 9.2.3 (1).)
device
R
No need to set.
®
device assignment parameters
device assignment parameter setting request (Y1008)
R
device assignment parameters to the buffer
R
MELSEC-Q
Setting method
device assignment parameter
R
device assignment parameter
R
9 - 39