Table of Contents
Advertisement
Set Up and Maintenance
When a node is initially added it is set up with a default configuration.
Node
PLC input signal
1
Name of signal 600..663, if there is one
2
Name of signal 664-727, if there is one
3
Name of signal 728..791, if there is one
4
No default is set up
5
No default is set up
6
No default is set up
Note: The PLC signals presented in the combo box lists are those that existed when the form was
opened. If you open the PLC and change these names at the same time as an IO Setup or IO Map
form is open, the change will not be displayed until an IO form is opened the next time. The best
way is therefore to first create all names in the PLC, then configure the IO.
160
PLC output signal
Name of signal 800..863, if there is one
Name of signal 864-827, if there is one
Name of signal 828..891, if there is one
No default is set up
No default is set up
No default is set up
9836 3521 01
Advertisement
Table of Contents
