D-Link AC750 User Manual page 75

Wireless dual band router
Hide thumbs Also See for AC750:
Table of Contents

Advertisement

Section 3 - Configuration
My IPv6
Select IPv6 In IPv4 Tunnel if you wish to configure the IPv6 connection
Connection is:
to run in IPv4 Tunnel mode. IPv6 over IPv4 tunnelling encapsulates
IPv6 packets in IPv4 packets so that IPv6 packets can be sent over an
IPv4 infrastructure.
IPv6 in IPv4 Tunnel Settings
Remote IPv4
Enter the IPv4 remote address.
Address:
Remote IPv6
Enter the IPv6 remote address.
Address:
Local IPv4
Displays the current local IPv4 address.
Address:
Local IPv6
Enter the IPv6 local address.
Address:
Subnet Prefix
Enter the IPv6 subnet prefix length.
Length:
D-Link DIR-819 User Manual
IPv6 in an IPv4 Tunnel
IPV6 CONNECTION TYPE
DIR-819
IPV6
IPV6
IPV6
Use this section to configure your IPv6 Connection Type.If you are unsure of your connection method, please contact your Internet
Service Provider.
Save Settings
Don't Save Settings
IPV6 CONNECTION TYPE
Choose the mode to be used by the router to connect to the IPv6 Internet.
My IPv6 Connection is:
IPv6 in IPv4 Tunnel
IPV6 IN IPV4 TUNNEL SETTINGS
Enter the information provided by your Internet Service Provider (ISP).
Remote IPv4 Address :
Remote IPv6 Address :
Local IPv4 Address :
Local IPv6 Address :
Subnet Prefix Length :
IPV6 DNS SETTINGS
Obtain DNS server address automatically or enter a specific DNS server address.
ž Obtain IPv6 DNS Servers automatically
š Use the following IPv6 DNS Servers
Primary DNS Address :
Secondary DNS Address :
LAN IPV6 ADDRESS SETTINGS
Use this section to configure the internal network settings of your router. If you change the LAN IPv6 Address here, you may need to
adjust your PC network settings to access the network again.
Enable DHCP-PD :
LAN IPv6 Address :
LAN IPv6 Link-Local Address : ffff::fff:ffff:ffff:1234 /64
ADDRESS AUTOCONFIGURATION SETTINGS
Use this section to setup IPv6 Autoconfiguration to assign IP addresses to the computers on your network. You can also enable DHCP-PD
to delegate prefixes for routers in your LAN.
Enable Automatic IPv6 address assignment :
Enable Automatic DHCP-PD in LAN :
Autoconfiguration Type :
SLAAC+RDNSS
SLAAC+Stateless DHCP
Stateful DHCPv6
Router Advertisement Lifetime :
SETUP
/64
(minutes)
71

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents