The Bandwidth/Sweep Menus - HP 86140A Series User Manual

Using the Optical Spectrum Analyzer

The Bandwidth/Sweep Menus

The Bandwidth/Sweep Menus
The Bandwidth/Sweep softkeys are accessed by using the front-panel Band-
width/Sweep key or the Measure menu Bandwidth/Sweep selection on the
menu bar. If you wish to change bandwidth or sweep settings, the following
functions and setup panels are available:
Function
Resolution Bandwidth
Video Bandwidth
Sweep Time
Repeat Sweep
Single Sweep
Trigger Mode....
Internal
Gated
External
ADC+, ADC-, and ADC AC
Trigger Delay
Synch Out
3-14
See....
"To change the resolution bandwidth" on page 3-15
"To change the video bandwidth" on page 3-15
"To change the sweep time" on page 3-16
"To turn repeat sweep on and off" on page 3-17
"To perform a single sweep" on page 3-17
"To select the internal trigger" on page 3-18
"To select a gated trigger" on page 3-18
"To select an external trigger" on page 3-19
"To select the trigger" on page 3-19
ADC
"To set the trigger delay" on page 3-20
"To select the synchronous output" on page 3-20