Table of Contents
Advertisement
CA-4150
Installation
Remove all packing materials from the CA-4150. Check if all foam and plastic padding is removed.
Fit the equipment to a 19" rack. Connect all cables.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 240V power, or vice versa.
Install this device on a flat surface, not bending or curved.
Do not supply power before all components of the system are set up and connected properly.
Mode Selector
Flip the switches on/off to set one of the 9 available modes. See the chart below for more information.
Operation Modes
Operation
DIP switches
Mode
#1
#2
1
OFF
OFF
2
ON
OFF
3
OFF
ON
4
ON
ON
5
OFF
OFF
6
ON
OFF
7
OFF
ON
8
ON
ON
9
–
Ordercode: D4512
#3
MT
OFF
OFF
Ch A/B/C/D – ALL STEREO
OFF
OFF
Ch A/B/C/D – ALL PARALLEL
OFF
OFF
Ch A/B – BRIDGED, Ch C/D – BRIDGED
OFF
OFF
Ch A/B – PARALLEL, Ch C/D – PARALLEL
ON
OFF
Ch A/B – STEREO, Ch C/D – BRIDGED (FULL RANGE)
ON
OFF
Ch A/B – PARALLEL, Ch C/D – BRIDGED (FULL RANGE)
ON
OFF
Ch A/B – STEREO, SUB (Ch C/D – BRIDGED, INPUT= Ch C)
ON
OFF
Ch A/B – STEREO, SUB (Ch C/D – BRIDGED, INPUT= Ch A+B)
–
–
ON
Mute the amplifier
Description
7
Fig. 03
Advertisement
Table of Contents
