Digital Watchdog DWC-MTT4Wi36 User Manual page 25

1. Enable region intrusion detection alarm and set the alarm holding time.
2. Set alarm trigger options. The setting steps are the same with that of motion
detection. Please refer to motion detection chapter for details.
3. Click "Save" button to save the settings.
4. Set the alarm area of the intrusion detection. Click "Area" tab to go to the interface as
shown below.
7. Set the alarm area number on the right side. You can add 4 alarm areas at most.
8. Click "Draw Area" button and then click around the area where you want to set as the
alarm area in the image on the left side (the alarm area should be a closed area). Click
"Stop Draw" button to stop drawing. Click "Clear" button to delete the alarm area.
Click "Save" button to save the settings.
9. Set the schedule of the intrusion detection. The setting steps of the schedule are the
same with that of motion detection. Please refer to motion detection chapter for
details.
Application Scenario Illustration
1. Auto-focusing function should not been enabled for intrusion detection. If enabled, the
25