Bit Switch Programming
Do not change the bit switches unless you are told to do this by the manufacturer.
1. Start the SP mode. Select the "Service" menu with "s/t" keys.
2. Press the "OK" key three times.
3. To select a bit switch, press the "/" keys.
4. Push the OK key.
5. Set the value with these keys:
• [Left] [Right]: Moves the cursor to one of the adjacent bits.
• [Up] [Down]: Changes a bit between "0" and "1".
• [Escape]: Goes out of the program without saving changes.
• [OK]: Goes out of the program and saves changes.
• The digit at the left [A] is bit 7 and the digit at the right [B] is bit 0.
1. Push the "Escape" key one or more times until the menu "SP mode (Service)" is shown.
2. Select "End" and push the OK key.
Service Program Mode
5
141