Programming The Primary Filtration - Sundance Spas Kingston 980 Series Owner's Manual

980™ Series
12.3

Programming the Primary Filtration

To access the "Primary" feature, tap
menu, Figure 12.3a, to enter the "Primary" programming, Figure 12.3b.
If the Primary tab does not appear on the LCD display, swipe the screen
upward to view additional options.
During a primary filtration, the circulation pump, CLEARRAY and ozone
unit (if applicable) are activated. The factory default cycle starts at 12:00
AM and last for 8 hours. If you elect to keep this setting, then you can
skip this section.
In extreme bitter cold weather, where freezing can occur,
we recommend you program the circulation pump to run 24
hours. Refer to the "Winterizing" section on page 62.
Any time the circulation pump runs outside of a program cycle, e.g. for
heating, that run time will be deducted from the next primary filter cycle.
For example, the primary filter cycle is set to 8 hours every 24 hours but
the circulation pump comes on for 2 hours to heat the water after the
cycle has finished. The next primary filter cycle will only be for 6 hours
not 8 hours.
A. To change the default cycle (Figure 12.3c):
1. Tap
Start
2. Swipe the hour to scroll and select the start time. To
switch from "AM" to "PM" you must round a 12-Hour
period.
3. Tap Set
4. Tap
End
5. Swipe the hour to scroll and select the end time. To
switch from "AM" to "PM" you must round a 12-Hour
period.
6. Tap Set
7. Tap to return to the Heat and Filter Menu. Tap again to return to
the Settings Menu.
Page 46
Auto
6:45
Heat & Filter
Day
Primary...
Secondary...
Figure 12.3a
to activate the programming settings.
to accept and save the change.
to program the end time for the cycle.
to accept and save the change.
from the Heat and Filter
Primary...
Auto
6:45
Filter 1
Start End
12:00a 8:00a
Set
Figure 12.3b
Auto
6:45
Filter 1
Start End
5:00p 8:00p
5 00
pm
Set
Figure 12.3c