Sundance Spas Kingston 980 Series Owner's Manual page 25

WARNING:
!
Never leave chemicals opened and accessible to anyone.
Use chemicals according to the vendors instructions. Always
store chemicals in a safe and/or locked location. Keep away
from and out of reach of children.
6. Establish A Stable Sanitizer Reading
Establish a stable sanitizer reading no less than 1.0 ppm free
chlorine or 2.0 ppm bromine. To ensure healthy water conditions,
always maintain a constant sanitizer reading within the levels
recommended on the inside cover of this manual. If sanitizer levels
cannot be stabilized, perform the decontamination procedure steps
9-15 on the following page.
Note: The "decontamination procedure" steps 9-15 should also be
used after the hot tub has been "Winterized" (Section 13.8) or has been
sitting without power for an extended period.
7. Set Hot Tub To Heat
To warm hot tub water to a comfortable temperature, follow these
steps:
• The LCD display on the control panel displays the actual temperature
of the hot tub water. Press either the COOLER (
( ) button once to display the "set" temperature for 5 seconds. If
you want the water to heat to a different temperature, simply press
COOLER or WARMER within 5 seconds. The set temperature
increases or decreases by one degree each time either button is
pressed.
• The heater will turn off when the temperature corresponding to the
thermostat setting is achieved.
Important Heater Details:
• The maximum temperature for which the hot tub can be set is
104°F (40°C) and the minimum is 65°F (18.33°C).
• For hot tubs powered with a 40 amp service, turn off jets pump #1
and jets pump #2 to operate heater.
• Setting the thermostat at maximum will not accelerate the heating
process. This will only result in a higher ultimate temperature.
• The heater operates until the water reaches the programmed "set
temperature," then turns off. The heater will reactivate after the
water cools to approximately 2° below the "set temperature."
8. Place Cover On Hot Tub
• Keeping the insulating cover in place anytime the hot tub is not in
use will reduce the time required for heating, thereby minimizing
operating costs.
• The time required for initial heat-up will vary depending on the
starting water temperature.
RISK OF POISONING OR DEATH.
980™ Series
) or WARMER
Page 19