Checking and refilling
Read and observe
and
Check the coolant under the following conditions and refill.
The vehicle is on a horizontal surface.
The engine is not warm (if the engine is warm, the test results could be in-
accurate).
The engine is turned off.
Check the coolant level - the coolant level must be between the marks
and
» Fig.
324. If the coolant level is below the mark
B
Refilling
The coolant expansion tank must always contain a small amount of coolant
»
.
›
Place a cloth over the cap of the coolant expansion tank and unscrew the cap
carefully.
›
Always top up using the correct specification of fluids.
›
Turn the cap until it clicks into place.
The specification of the coolant is shown on the coolant expansion reser-
voir» Fig.
324.
If no specified coolant is available, use only distilled or demineralised water and
have the mixing ratio of water and coolant additive corrected by a specialist
garage as soon as possible.
Fig. 324
Coolant expansion reservoir
on page 280 first.
, refill the coolant.
B
CAUTION
If the expansion tank is empty, do not top up with coolant. The system could
■
aerate - risk of damaging the engine!
the engine and seek assistance from a specialist garage.
Do not fill the coolant above the mark
■
coolant could press out of the cooling system - there is a risk of damage to the
engine parts.
If it is not possible to add coolant,
■
seek assistance from a specialist garage.
A coolant additive which does not correspond to the correct specification
■
can reduce the anti-corrosion effect of the cooling system - there is a risk of
damage to the cooling system and the engine.
If water other than distilled (demineralised) water is used, then have the
■
coolant replaced by a specialist garage - there is a risk of engine damage.
A loss of coolant could be due to leaks in the cooling system - there is a risk
■
of engine damage. Switch off the engine and seek assistance from a specialist
garage.
Note
A coolant level which is too low is indicated in the instrument cluster by the
A
warning light and a corresponding message
inspecting the coolant level directly at the reservoir from time to time.
Brake fluid
Check the brake fluid under the following conditions.
The vehicle is on a horizontal surface.
The engine is turned off.
Check brake fluid level - the brake fluid level must be between the markings
"MIN" and
"MAX"» Fig.
Do not drive the vehicle. Switch off
» Fig.
324. When it heats up, the
A
stop driving! Switch off the engine and
» page
48. We still recommend
Fig. 325
Brake fluid reservoir
325.
Inspecting and replenishing
281