Skoda OCTAVIA Owner's Manual page 186

›
Route guidance is enabled - From the main Navigation menu, tap the func-
tion surface  → Name destination.
›
If the destination entry menu » Fig. 215
then tap on the function surface  →
Enter dest.
›
Enter the destination address and then confirm.
Relevant names (e.g. Place/street names) are offered in the entry line during
entry, depending on the context. Previously entered names are offered on a
preferential basis.
The location of the destination offered, which is specified in the entry line in
parentheses, can be displayed in the map by tapping the function surfaceMap.
List of locations visited
There is a possibility that a map with a list of places of the same name will be
displayed during entry» Fig. 215 - .
The list of places visited can also be called up during address entry by pressing
the function surface  .
In the list of visited locations, there is a maximum of 6 locations shown,
marked with a letter. These places are then marked with the symbol  in the
map and a letter, which coincides with the character in the list of visited loca-
tions.
If several places were visited, then the list can be scrolled through by turning
the controller  (not applicable to Infotainment Columbus) or moving the slid-
er.
Note
When entering a street name, there is an option of entering the centre of a
■
given place as a destination instead of a street name, by tapping on function
surface Centre.
After entering the street name, the house number or intersection can be en-
■
tered using the name / number of the intersecting road.
184
Infotainment
-  is not shown using the address,
» Fig. 213 on page 182.
2
Enter destination on the map and using GPS coordinates
Fig. 216 Enter destination: via the map point/using GPS coordinates
Show map
›
Route guidance is disabled - From the navigation main menu, the function
surface  .
›
Route guidance is enabled - From the main Navigation menu, tap the func-
tion surface  → Name destination.
›
Then tap the function surface  →
Enter destination via the point
›
While entering a destination into the map, the map scale displayed can be
changed manually » page 190, Types of manual scale change.
›
By sliding the screen move the desired destination into the cross-hair
» Fig. 216 - .
›
Confirm the destination entry by tapping the function surface  .
through via coordinates
›
The function surface with the desired GPS value coordinates for latitude 
and geographical longitude  » Fig. 216
›
Set the desired value and the destination input by pressing the function sur-
face  .
If information is available about the point entered in the navigation data, then
these will be displayed instead of the GPS coordinates (e.g. address
» Fig. 216).
» Fig. 213 on page 182.
5
- .
A