Environment - Kyocera ECOSYS P2235dn Service Manual

2 Installation

2-1 Environment

Installation environment
1. Temperature: 50 to 90.5°F (10 to 32.5°C) (But humidity should be 70% or less when the temperature is 90.5°F
(32.5°C).)
2. Humidity: 10 to 80%(But the temperature should be 86°F (30°C) or less when humidity is 80%.)
3. Power AC100V 50/60Hz 8.1A or more
AC120V 60Hz 8.1A or more
AC220 to 240V 50HzA 4.2A or more
4. Frequency fluctuation: 50Hz+/-2% or 60Hz+/-2%
Installation location
The operative environmental conditions are as follows:
Adverse environmental conditions may affect the image quality. It is recommended to use the machine as follows:
Humidity: 36 to 65% Temperature: 60.8 to 80.6°F or less (16 to 27°C).
Avoid the following locations when selecting a site for the machine.
Avoid locations near a window or with exposure to direct sunlight
Avoid locations with vibrations
Avoid locations with rapid temperature fluctuations
Avoid locations with direct exposure to hot or cold air
Avoid poorly ventilated locations
If the floor is delicate, when this machine is moved after installation, the floor material may be damaged by the casters.
During operation, some ozone is released, but the amount does not cause any ill effect to one's health.
However, when using for a prolonged time in a poorly ventilated room or when printing large number of copies, it may
become unpleasant with smell. To maintain the appropriate environment for copy work, it is suggested that the room be
properly ventilated.
Installation space
300mm or more
200mm or more
300mm or more
500mm or more
Figure 2-1
2-1
2RV/2RW/2RX/2RY/3RA
300mm or more