Making The Measurement; Results - Agilent Technologies E4404B Operation Manual

Making GSM Base Station Measurements
Making the Transmitter Power Measurement

Making the Measurement

1. Press the
2. Press the
Factory default parameter settings provide a GSM compliant
measurement. For special requirements, you may need to change
default settings:
• Mode setup and frequency/channel parameters.
• Measurement setup parameters.
Parameters that exist under the
NOTE
to be changed. Any changes from the default values may result in
invalid measurement data.

Results

An example screen from a Transmitter Power (single burst)
measurement is shown below in
multiple burst measurement is shown in
Figure 3-12 Transmitter Power Result - Single Burst
3-20
key.
Measure
Transmitter Power
Use the and
Mode Setup
parameters for all measurements made within the current mode. For
further information refer to Chapter 1 of this document.
These are measurement specific parameters changed using the
Measurement setup (
to default settings at any time by pressing
and
Restore Meas Defaults
setup parameters, refer to the ESA Series Spectrum Analyzers GSM
Measurement Personality User's Guide.
key.
Frequency Channel
) menu. Parameters can be returned
Meas Setup
. For further information on measurement
Meas Setup Advanced
Figure 3-12
Figure
keys to change these
,
Meas Setup More (1 of 2)
key seldom need
(below). An example of a
3-13.
Chapter 3