Inspecting Results
1. Select a specific spur:
• Press
Meas Setup
have been measured, the current spur number is highlighted in
the results table.
• Move up and down the list of spurs using the numeric keypad or
tab keys.
2. Inspect a specific spur by using:
• Parameters contained under the
front panel keys.
•
,
Sweep Time
Res BW
,
Meas Setup
and Inspect Spur
Troubleshooting Hints
• If an external attenuator is used, be sure to include the attenuation
value in the measurement. This can be done under the
menu.
Input, Ext Atten
• If an external preamplifier is used, be sure to include the gain value
in the measurement. This can be done under the
menu.
Chapter 4
Making GSM Air Interface Measurements
Making the Out-of-Band Spurious Measurement
,
and
Inspect Spur
Inspect Spur ON
Frequency
and
parameters, contained under
Video BW
.
. If any spurs
,
and
Span
Amplitude
Input and Ext Gain
4-9