Making The Measurement; Power Time Custom Masks - Agilent Technologies E4404B Operation Manual

Making GSM Base Station Measurements
Making the Power Versus Time Measurement

Making the Measurement

1. Press the
2. Press the
Factory default parameter settings provide a GSM compliant
measurement. For special requirements, you may need to change
default settings:
• Mode setup and frequency/channel parameters.
• Measurement setup parameters.
Parameters that exist under the
NOTE
to be changed. Any changes from the default values may result in
invalid measurement data.

Power Time Custom Masks

For the Power vs Time measurement, you can define a user
configurable limit mask to apply to the measured burst. This feature
can only be accessed via SCPI commands. For further information refer
to the ESA-E Series Spectrum Analyzers GSM Measurement Personality
Programing Guide.
3-14
key.
Measure
Power vs Time
Use the and
Mode Setup
parameters for all measurements made within the current mode. For
further information refer to Chapter 1 of this document.
These are measurement specific parameters changed using the
Measurement setup (
to default settings at any time by pressing
and
Restore Meas Defaults
setup parameters, refer to Chapter 5 of the ESA-E Series Spectrum
Analyzers GSM Measurement Personality User's Guide.
key.
Frequency Channel
) menu. Parameters can be returned
Meas Setup
. For further information on measurement
Meas Setup Advanced
keys to change these
,
Meas Setup More (1 of 2)
key seldom need
Chapter 3