Making The Measurement - Agilent Technologies E4404B Operation Manual

Making the Measurement

1. Press the
2. Press the
Factory default parameter settings provide a GSM compliant
measurement. For special requirements, you may need to change
default settings:
• Mode setup and frequency/channel parameters. Use the
• Measurement setup parameters. These are measurement specific
The following keys provide useful measurement functionality:
• Changing between multiple, single and swept modes:
• Changing between modulation and switching:
• To change the table display:
Parameters that exist under the
NOTE
to be changed. Any changes from the default values may result in
invalid measurement data.
Chapter 3
Making the Output RF Spectrum (ORFS) Measurement
key.
Measure
Output RF Spectrum
and
Frequency Channel
measurements made within the current mode. For further
information refer to Chapter 1 of this document.
parameters changed using the Measurement setup (
menu. Parameters can be returned to default settings at any time by
pressing ,
Meas Setup
further information on measurement setup parameters, refer to
Chapter 5 of the User's Guide for the ESA Series Spectrum
Analyzers GSM Measurement Personality.
Press followed by
Meas Setup
Press followed by
Meas Setup
The table display can be changed to display results, the GSM
specification limits, or the margins. Press the
followed by the
Table Display
settings.
Making GSM Base Station Measurements
key.
keys to change these parameters for all
and
More (1 of 2) Restore Meas Defaults
Meas Method
Meas Type
menu key to toggle between these
Meas Setup Advanced
Mode Setup
Meas Setup
. For
.
front panel key
Display
key seldom need
)
3-5