Philips EL1.1U Service Manual page 24

EN 24 5. EL1.1U
Important remark:
release RESET AUDIO and
SOUND_ENABLE 2 sec after
entering stand-by to save power
*
Only applicable for sets with CableCARD
Service Modes, Error Codes, and Fault Finding
*
POD
Transfer Wake up reasons to the
Stand- by µP.
Images are re-transferred to DDR-RAM from
Flash RAM (verification through checksum).
MIPS image completes the application reload,
stops DDR-RAM access, puts itself in a
sleepmode, and signals the standby µP when
the Stand-by mode can be entered.
DDR-RAM is put in self refresh mode and the images
are kept in the hibernating DDR-RAM.
Wait 5ms
Switch Viper in reset state
Wait 10ms
Switch the NVM reset line "high".
Disable all supply related protections and switch "off"
the +2V5, +3V3 DC/DC converter.
Wait 5ms
Switch "off" the remaining DC/DC converters
Switch "off" all supplies by switching "high" the POD-
MODE and the ON-MODE I/O lines.
Stand-by
TM
slot (POD)
Figure 5-8 "Semi Stand-by" to "Stand-by" flowchart
Semi Stand-by
*
action holder: MIPS
action holder: St-by
autonomous action
For PDP this means
CPUGO becomes low.
F_15400_099.eps
020206