Table of Contents
Advertisement
EN 12
4.
4.3
Assy/Panel Removal
4.3.1
Rear Cover
Warning: Disconnect the mains power cord before you remove
the rear cover.
1. Place the TV set upside down on a table top, using the
foam bars (see part "Foam Bars").
Caution: do not put pressure on the display, but let the
monitor lean on the speakers or the Front cover.
2. Remove all screws that secure the rear cover.
3. Lift the rear cover from the cabinet cautiously. Make sure
that wires and other internal components are not damaged
during cover removal.
4.3.2
Keyboard Control Panel
1. Remove the screws [1] that secure the panel.
2. Disconnect the cable [2] from the panel.
3. Remove the panel.
When defective, replace the whole unit.
Figure 4-7 Keyboard Control panel, Side I/O panel and LED panel.
4.3.3
Side I/O Panel
1. Disconnect the cables [3][4][5] from the panel.
2. Remove the panel from its brackets [6].
When defective, replace the whole unit.
4.3.4
LED Panel
1. Disconnect the cable [7] from the panel.
2. Remove the panel from its bracket [8].
When defective, replace the whole unit.
4.3.5
Speakers
After removal of the rear cover, you can access the speakers.
EL1.1U
Mechanical Instructions
1
2
3
4
5
7
G_16290_071.eps
4.3.6
Stand-by Power Supply/Audio Amplifier Panel (if present)
1. Disconnect all cables [1] from the panel.
2. Remove the fixation screws [2] from the panel. The
positioning might differ from the locations as indicated in
Figure "Stand-by/Audio panel".
3. Take the panel out of its brackets (it hinges at the bottom
side).
1
4.3.7
LCD Supply Panel
1. Disconnect all cables [1] from the panel.
2. Remove the fixation screws [2] from the panel.
3. Take the panel out of its brackets (it hinges on the right
6
side).
26 and 32-inch models
2
1
8
2
2
310106
2
2
2
Figure 4-8 Stand-by/Audio panel
37 and 42-inch models
2
1
2
2
2
1
1
2
Figure 4-9 LCD supply panel(s)
F_15420_042.eps
070605
1
1
1
G_16290_088.eps
030206
Advertisement
Table of Contents
