Table of Contents
Advertisement
21
Batteries
CAUTION: When the battery symbol appears, you should
replace the batteries immediately. Only use CR2032
batteries.
Your BGStar Meter comes with two pre-installed, CR2032, 3 volt,
lithium batteries. Battery #1 powers the backlight and battery
#2 powers the basic meter functions. When the power from
battery #2 is low, the low battery symbol or dead battery symbol
will be displayed on the screen until you change battery #2.
When replacing battery #2, the time and date information may
be lost after the battery is removed from the meter. If this
happens, activate the meter after installing the new battery
and it will prompt you to set the time and date. Correct time
and date settings are needed to get correct averages. Removing
the batteries does not affect the meter's memory or previously
stored user settings, such as time format, alarms, etc.
Note: Dispose of used batteries according to your local
environmental regulations. Your meter is an electronic device.
When disposing of your meter follow all local environmental
regulations.
Replacing the Batteries
[1] Open Battery Door: Make sure the meter is
deactivated. Turn the meter so you are looking
at the battery door. Press the battery door clip
to open. Remove the battery door. Be careful
not to misplace the battery door.
58
[2] Remove and Install the meter battery:
To remove the used battery, pull the appropriate
tab to pop out the battery. Install the new battery
with the positive (+) sign facing up towards you.
[3] Remove and Install the
backlight battery: To remove the
used battery, pull the appropriate tab
to pop out the battery. Install the new
battery with the positive (+) sign facing
up towards you.
[4] Close Battery Door: Angle the battery
door back onto the meter and swing
down until it snaps gently into place. Make
sure that the battery door is completely closed
before using.
IMPORTANT: When the meter is deactivated
and you are replacing battery #2, the time and date
information may be lost after the battery is removed
from the meter. If this happens, activate the meter after
CR2032
CR R
CR
CR R
CR20
R
2032 2 2
20
2
installing the new battery and it will prompt you to set the
time and date.
C
CR2032
C
C
C
C
C
C
C
C
CR203
CR203
R
R 203
R
R 2032
CR2032
CR2032
2 2
CR2032
CR2032
2 2
CR R R R
CR2032
R
R
R R R R R 20
20
2032
2
2 2
C
CR2032
C
C
C
CR203
CR203
C
C
C
C
C
R
R
R 2032
R 203
59
Hide quick links:
Advertisement
Table of Contents
