Table of Contents
Advertisement
Important BGStar Control Solution information:
[1] Use only BGStar Control Solution with your BGStar
System.
[2] Always replace the cap on the control solution bottle
immediately after use.
[3] Do not add water or any other liquid to control solution.
[4] Control solution tests should be performed within the
system operating temperature range of 10°C to 40°C.
How to perform a control solution test:
[1] Inserting a BGStar Test Strip:
Insert a new BGStar Test Strip
into the meter. The meter will be
activated when the test strip is fully
inserted.
[2] Meter Ready for Test:
The meter now displays the droplet symbol and the word
"Fill". The BGStar System is now ready for you to apply control
solution. You do not need to set a
calibration code for this meter.
[3] Applying Control Solution:
Shake the control solution bottle.
Discard the first drop of control
solution and wipe the bottle tip clean
using a clean tissue or paper towel.
18
Dispense a second drop onto a clean surface, such as an
unused resealable plastic bag.
Bring the tip of the test strip to the control solution sample.
The BGStar System will automatically detect if a test is per-
formed with BGStar Control Solution.
This is the visual fi ll window.
DO NOT PUT CONTROL
SOLUTION HERE.
Apply control solution here.
When control solution is applied, the visual fill
window on the BGStar Test Strip turns blue. Your
meter will beep once indicating that you should
remove the tip of the BGStar Test Strip from the
control solution sample. On the meter display, the
droplet symbol fills. The scrolling bar and 1-2-3
indicates that the meter is calculating your results.
The entire visual fi ll
window will turn blue.
Droplet
Symbol:
19
Hide quick links:
Advertisement
Table of Contents
