Software Installation, Discovery And Configuration; Recommended Web Browser Settings; Connecting To A Network Server - HP StorageWorks D2D User Manual

This ensures good backup performance. However, only the backup server can be backed up; other
devices on the network must be configured as clients that back up to the designated backup server over
the business network, which may impact performance.
PC
Storage
Server
Figure 9 Connecting to a network server
This configuration, illustrated in
the storage server to support the direct connection to the HP D2D Backup System. Use the cable supplied
with the HP D2D Backup System to connect to the Gigabit network card on the server.
NOTE:
If the server has a 10/100 Base-T network card, you will need a cross-over network cable (not supplied).
A better solution, to ensure optimum performance, is to purchase and install a Gigabit network card.
Software installation, discovery and configuration
There are three stages to installation:
• Install all the required drivers
• Discover the HP D2D Backup System on the network, give it a name and, if DHCP is not
supported, assign network settings
• Create a base configuration to get started
Dynamic (DHCP) addressing is enabled by default on the HP D2D Backup System. If your network
supports DHCP, all the required network parameters will be assigned automatically. If your network uses
static IP addressing, you will need to assign network settings manually (IP address, subnet mask and
gateway).
For Windows users, the recommended way to set up the HP D2D Backup System network is to run the
Installation wizard from the HP StorageWorks CD-ROM, as described in
Linux users should download the latest patches for their operating system and refer to the "Linux
Configuration Guide" on the HP StorageWorks CD-ROM for configuration instructions.

Recommended web browser settings

The web browser used to communicate with the D2D Backup System must have Active Scripting or JAVA
scripting enabled. If it does not, some of the browser buttons may not be displayed.
26
Connecting and installing the HP D2D Backup System
Server
Switch
Supplied
cable
Figure 9
Server
LAN
HP StorageWorks D2D
Backup System
on page 26, requires a spare Gigabit network port or card on
"Installation wizard" on page 39.