General Tab; Discovery Tab - HP StorageWorks D2D User Manual

General tab

You do not normally need to make any changes on the General tab. The Initiator Node Name is
generated automatically, which guarantees that it will be unique on your network. The other fields
relate to authentication and are not needed for the HP D2D Backup System. Only use them if required
to by your IT policy. (If you use Secret to enter an encryption string in this dialog to authenticate
targets, you must also enter the same string on the Web Management interface in the iSCSI page. (See
"iSCSI (Status)" on page 77.)
NOTE:
When you use the Web Management Interface to create an additional device for your host, you must
provide the iSCSI Initiator Name. This is the Initiator Node Name found on the General tab.

Discovery tab

You must enter the IP address or fully qualified domain name of the HP D2D Backup System (for example,
myhpd2d.mydomain.com) to add it as a target portal for the host on the Discovery tab. Do not change
the Port; it should be 3260.
48
Advanced installation