HP T1000 xr Installation Instructions

hp uninterruptible
power system T1000 xr/
T1500 xr models

installation instructions

Read Instructions Completely
Before Beginning Installation Procedures
Hewlett-Packard Company shall not be liable for technical or editorial errors or
omissions contained herein. The information in this document is provided "as is"
without warranty of any kind and is subject to change without notice. The warranties
for HP products are set forth in the express limited warranty statements
accompanying such products. Nothing herein should be construed as constituting an
additional warranty.
HP Uninterruptible Power System T1000 XR/T1500 XR Models Installation
Instructions
Second Edition (August 2002)
Part Number 215396-022
215396- 022
HP CONFIDENTIAL Writer: Kerri Morgan Codename:Sherman Part Number: 215396-022 Last Saved On: 8/14/02 9:50 AM
Overview
These instructions show how to install an uninterruptible power
system (UPS). For detailed information about the UPS, refer to the
UPS user guide on the Power Products Documentation CD.

Important Safety Information

Before installing this product, read the Important Safety
Information document provided.
WARNING: To prevent personal injury from electric shock and
hazardous energy levels, the installation of options and routine
maintenance and service of this product must be performed by
individuals who are knowledgeable about the procedures,
precautions, and hazards associated with AC power products.
WARNING: To prevent personal injury from earth conductor
leakage current:
•
Do not operate a UPS that is disconnected from the utility
power source.
•
Disconnect protected devices from the UPS before
disconnecting the UPS from utility power.
•
Use the Test/Alarm Reset button to test the batteries rather
than unplugging the UPS. Refer to the UPS user guide for
more information on the operation of the UPS.
Regulatory Compliance
Identification Numbers
For the purpose of regulatory compliance certifications and
identification, the UPS models are assigned series numbers, also
identified on the Regulatory Compliance label located on the rear
of the UPS. For certification information, refer to the series
number:
• T1000 XR NA series number: EO3017
• T1000 XR H INT'L series number: EO3017i
• T1500 XR NA series number: EO3018
• T1500 XR JPN series number: EO3018j
• T1500 XR H INT'L series number: EO3018i
NOTE: The rating label on the device provides the class (A or B) of the
equipment. Class B devices have a Federal Communications Commission
(FCC) logo or FCC ID on the label. Class A devices do not have an FCC logo
or FCC ID on the label. After you determine the class of the device, refer to
the UPS user guide for complete regulatory compliance notices.
Weight — T1000 XR
WARNING: The UPS weighs 15.6 kg (34.5 lb) when
fully assembled. To prevent personal injury or damage
to the equipment:
15.6 kg
•
Observe local occupational health and safety
34.5 lb
requirements and guidelines for manual material
handling.
•
Obtain adequate assistance to lift and stabilize the
UPS during installation or removal.