Kyocera FS-1060DN Service Manual page 76

1. Remove two screws and then remove
the power source PWB.
2. Check or replace the main PWB,high
voltage PWB and power source PWB,
and refit all the removed parts.
Caution: When fitting the controller unit,
make sure that the cover-open lever is
seated above the switch actuator so
that the lever can turn on the cover
switch above the power PWB.
When performing service, be sure to
keep the front and rear covers opened.
When installing the unit, be sure to
open the front and rear cover.
Power souce PWB
Screw
Figure 1-5-15
Cover open/close lever B
Front cover
Cover open/close lever A
Cover switch
Figure 1-5-16
1-5-10
2M2/2M3
Screw
Rear cover
Power source PWB