Kyocera FS-1060DN Service Manual page 62

Problem
(5)
Duplex solenoid
does not operate.
(25/26 ppm model
only)
(6)
Eraser lamp does
not turn on.
(7)
A paper jam in the
paper feed/convey-
ing section or fuser
section is indi-
cated when the
power switch is
turned on.
(8)
Attention indicator
is lit when the front
and rear cover is
closed.
Causes
1. Defective connector
cable or poor con-
tact in the connector.
2. Defective solenoid.
3. Defective PWB.
1. Defective connector
cable or poor con-
tact in the connector.
2. Defective Eraser
lamp.
3. Defective PWB.
1.
A piece of paper torn
from paper is caught
around registration
uplex
sensor or d sen-
sor.
2. Defective sensor.
1. Defective connector
cable or poor con-
tact in the connector.
2. Defective switch.
3. Failure of improper
controller unit
installation.
Check procedures/corrective measures
Reinsert the connector. Also check for continuity within the
connector cable. If none, replace the cable.
Duplex solenoid and relay PWB (YC2)
Relay PWB and main PWB (YC14)
Replace the duplex solenoid.
Replace the relay PWB or main PWB and check for correct
operation (see page 1-5-7).
Reinsert the connector. Also check for continuity within the
connector cable. If none, replace the cable.
Eraser lamp PWB and main PWB (YC20)
Replace the Eraser lamp PWB.
Replace the main PWB and check for correct operation
(see page 1-5-7).
Check visually and remove it, if any.
Replace the
registration sensor or d
Reinsert the connector. Also check for continuity within the
connector cable. If none, replace the cable.
Power source PWB (YC103) and main PWB (YC12)
Check for continuity across the cover switch. If there is no
continuity when the cover switch is on, replace the power
source PWB (see page 1-5-7).
Check that the cover open-close lever A turns on the cover
switch when the front and rear covers are closed.
If it won't turn on when covers are closed, re-seat the con-
troller unit.
1-4-16
2M2/2M3
uplex .
sensor