Table of Contents
Advertisement
34
www.electrolux.com
3. Replace the oven lamp with a
suitable 300 °C heat-resistant oven
lamp.
12. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
12.1 What to do if...
Problem
You cannot activate the
appliance.
You cannot activate the
appliance.
You cannot activate or op‐
erate the hob.
You cannot activate or op‐
erate the hob.
You cannot activate or op‐
erate the hob.
An acoustic signal sounds
and the hob deactivates.
An acoustic signal sounds
when the hob is deactiva‐
ted.
The hob deactivates.
Residual heat indicator
does not come on.
Automatic Heat Up func‐
tion does not operate.
Automatic Heat Up func‐
tion does not operate.
4. Install the glass cover.
Possible cause
The appliance is not con‐
nected to an electrical sup‐
ply or it is connected incor‐
rectly.
The fuse is blown.
You touched 2 or more
sensor fields at the same
time.
STOP+GO function oper‐
ates.
There is water or fat stains
on the control panel.
You put something on one
or more sensor fields.
You put something on the
sensor field
.
The zone is not hot be‐
cause it operated only for a
short time.
The zone is hot.
The highest heat setting is
set.
Use the same oven lamp type.
Remedy
Check if the appliance is
correctly connected to the
electrical supply.
Make sure that the fuse is
the cause of the malfunc‐
tion. If the fuse is blown
again and again, contact a
qualified electrician.
Touch only one sensor
field.
Refer to "Hob - Daily use"
chapter.
Clean the control panel.
Remove the object from
the sensor fields.
Remove the object from
the sensor field.
If the zone operated suffi‐
ciently long to be hot,
speak to an Authorised
Service Centre.
Let the zone become suffi‐
ciently cool.
The highest heat setting
has the same power as the
function.
Advertisement
Table of Contents
