Table of Contents
Advertisement
32
www.electrolux.com
11.2 Stainless steel or
aluminium appliances
Clean the oven door with a
damp cloth or sponge only.
Dry it with a soft cloth.
Do not use steel wool, acids
or abrasive materials as they
can damage the oven
surface. Clean the oven
control panel with the same
precautions.
11.3 Catalytic cleaning
CAUTION!
Do not clean the catalytic
surface with oven sprays,
abrasive cleaning agents,
soap or other cleaning
agents. This will damage the
catalytic surface.
Spots or discolouration of
the catalytic surface have no
effect on catalytic properties.
WARNING!
Keep children away when
you clean the oven at a high
temperature. The oven
surface becomes very hot
and there is a risk of burns.
CAUTION!
Always turn the oven light on
while using the catalytic
cleaning (if applicable).
Before activating the
catalytic cleaning remove all
the accessories from the
oven.
The walls with a catalytic coating are
self-cleaning. They absorb fat which
collects on the walls while the appliance
operates.
To support the self-cleaning procedure,
heat the empty oven on a regular basis.
Catalytic cleaning works only in the main
oven.
1. Clean the oven floor with warm water
and washing up liquid, then dry it.
2. Set the
function.
3. Set the oven temperature to 250 °C
and let the oven operate for 1 hour.
4. When the appliance is cool, clean it
with a soft and moist sponge.
11.4 Removing the shelf
supports
To clean the oven, remove the shelf
supports.
1. Pull the front of the shelf support
away from the side wall.
2. Pull the rear end of the shelf support
away from the side wall and remove
it.
1
The retaining pins on the
telescopic runners must
point to the front.
Install the shelf supports in the opposite
sequence.
CAUTION!
Make sure that the longer
fixing wire is in the front. The
ends of the two wires must
point to the rear. Incorrect
installation can cause
damage to the enamel.
2
Advertisement
Table of Contents
