Removing The Processor - HP Presario 5800 Series Maintenance & Service Manual

MSG Index |
Removal & Replacement
Removal and Replacement
Processor for Models 5822, 5827, 5832, 5834, and 5835
5800 Models with Pentium III Processor
5800 Models with Athlon Processor
Processor may vary from the one shown.
Removal Sequence
Chassis
Mass Storage Devices
Button Board
Digital Creativity
Imaging Center
Option Card Retainer
Graphics Board
PCI Cards
Memory
Processor
Processor Retention Clips
RTC Battery
System Board Cables
System Board
Parallel Port
Back I/O Panel
Power Supply
Back to Removal and Replacement
Maintenance & Service Guide
Presario 5800 Series Personal Computers
Home | Preface | Product Description
Illustrated Parts
| Jumpers & Switches
| Troubleshooting
| Specifications

Removing the Processor

1. Complete the preparation for
disassembly procedures.
2. Remove the chassis.
Caution: The processor may still
be very hot if the computer has
been running recently.
3. Remove the clip from the heat
sink.
4. Lift up the ZIF socket handle,
then lift the heat sink and
processor out of the socket.
Replacement
To reinstall the Celeron
processor, rub a thermal transfer
crayon on the bottom of the heat
sink, then reverse the steps
above.
NOTE: The thermal transfer
crayon replaces the thermal pad
used with earlier K6 processors.
|